古典吧>英语词典>pawl翻译和用法

pawl

网络  棘爪; 制转杆; 掣爪; 卡爪

复数:pawls 

英英释义

noun

  • a hinged catch that fits into a notch of a ratchet to move a wheel forward or prevent it from moving backward
      Synonym:detentclickdog

    双语例句

    • Heavy hammer on the pawl through the release of the lock device on Spindle lock spindles;
      重锤上的棘爪通过释放装置上的锁锭轴锁锭;
    • The pipe tongs is mainly composed of a fixed jaw, a movable jaw, a racket wheel, a spring, a pawl, a movable pin and a connecting pin;
      主要由固定钳口、活动钳口、棘轮、弹簧、棘爪、活动销和连接销等组成。
    • Analyzing the reasons of spring failure on pressing pawl of cutting machine and heat treatment
      剪板机压料爪子弹簧失效原因分析及处理
    • The fine blanking dies of the pawl and the chute used for the seat recliner were firstly introduced in this thesis, and failure analysis has been carried out in view of mechanical calculation, metallographic test, hardness test and SEM.
      本文首先针对棘爪、滑槽板两副精冲模具出现断裂的凸模,从力学强度校核、金相试验、硬度试验、断口电镜扫描等进行试验分析。
    • Move the feed dog up or down to perform adjustment, then securely tighten the screw. The fastening tool further includes a coil feeder ( 720) assembly having an indexing pawl ( 722).
      上下移动送布牙调节高度,然后拧紧紧固螺丝。紧固工具还包括具有分度棘爪的卷料进给组件。
    • A two-raking pawl mechanism is a kind of loading one used in a roadheader; its performance and property are unknown now.
      双耙爪是在掘进机上使用的一种装载机构,其性能和特征目前还不甚清楚。
    • A bracket will be installed within the transmissions to assure that the park pawl shaft remains properly in position.
      在变速器内安装保持架来确保驻车止动爪定位销处在正常位置。
    • Simulation and Analysis of a Two-raking Pawl Loading Mechanism
      双耙爪式装载机构的模拟分析
    • And adjusting the friction torque between the ratchet wheel and pawl can effectively increase the code discrimination performance of micro-electromechanical system code lock.
      通过控制棘轮棘爪处的摩擦力矩可有效提高微机电系统密码锁的鉴码性能。
    • This paper deels with the filling density calculation and design methods to determine the num-bers of the pawl and teeth of the ratchet wheel as well as linkage lengths of the mechanism.
      本文对该机构的纬密计算,棘爪数、棘轮齿数以及传动连轩长度的确定等设计方法均作了较为详细的介绍。