古典吧>英语词典>deceases翻译和用法

deceases

死亡

双语例句

  • In case a contractor deceases during the term of a contract, the successor of the deceased contractor may continue the contract.
    承包人在承包期内死亡的,该承包人的继承人可以继续承包。
  • The results show that pressure drop deceases with increased solid loading under the proper operating conditions only for the specially designated cyclones.
    研究结果表明:对于特定的旋风器,在适当的操作条件下,筒体压降随固气比的增加而减小。
  • The axial reflectivity sharply deceases as the ratio of body length to aperture side length increases, while the change caused by increase of body width is not obvious.
    轴向反射率随腔体长度与开口边长比值的增加而迅速减小,而腔体宽度增加引起的变化不明显。
  • As the temperature rises, the friction coefficient deceases.
    随温度升高,其摩擦因数降低;
  • Conclusions At present, the tabes dorsalis should be involved in the differentiation diagnosis for the deceases with the lesions of posterior roots, dorsal columns and peripheral nerve. It is important for patients with age 40~ 60 years or whose nerve conduction velocity is normal.
    结论目前对于定位于脊髓(尤其是腰髓)后根、后索以及周围神经病变的患者,尤其是年龄40~60岁、电生理检查神经传导速度正常者,需要注意鉴别脊髓痨。
  • The gust intensity deceases with the height by the negative exponential function also, while its decrease rate is smaller than that of the gust coefficient.
    阵风强度随高度也呈负指数函数形式递减,但其递减率要小于阵风系数的递减率。
  • When the temperature rises, the viscosity deceases, which is good for plasticizing.
    料筒中料温升高时黏度降低,有利于塑化;
  • The pruning method can permits us to directly get some undiscovered frequent patterns from some discovered frequent patterns, so that deceases quantity of candidate subtrees and time that used to count the frequency of their, thereby improves the efficiency of our algorithm.
    根据修剪策略,我们可以直接从某些已知频繁子树中产生某些未知频繁子树,因此减少了算法在候选子树的列举和支持度计算上的开销,从而提高了算法的效率。
  • The following conclusions can be drawn from the analysis: The axial force of hydrodynamic coupling deceases with the increasing of speed ratio at a constant filling rate; the axial force reaches the maximum at braking condition while minimum at rated condition.
    通过分析得出以下结论:在充液率一定的情况下,液力偶合器轴向力随转速比的增大而减小;在制动工况下轴向力最大,在额定工况下最小。
  • The precipitation pattern is consistent with orientation of orography, i.e. the rainfall increases on the windward side, while deceases on the lee side.
    由地形强迫产生的降雨量和地形走向相一致,迎风坡降雨量增加,背风坡降雨量减少,地形影响使浙江东部一带增加的平均降雨量约占该地区模拟平均总降雨量的40%左右。