chamfer
英 [ˈtʃæmfə(r)]
美 [ˈtʃæmfər]
n. 斜切面; 削角
复数：chamfers 现在分词：chamfering 过去分词：chamfered 过去式：chamfered 第三人称单数：chamfers
COCA.44768
牛津词典
noun
- 斜切面；削角
a cut made along an edge or on a corner so that it slopes rather than being at 90˚
英英释义
noun
verb
双语例句
- The specialized inspector inspects the bore diameter, pitch, chamfer and finish degree of bore wall.
加工完成后由专门检验员检验孔径、孔距、倒角大小、孔壁光洁度。 - Programming Method of Milling of Chamfer and Fillet Based on$ TC_DP
基于＄TCDP铣削斜面及倒圆角的程序编制方法 - If you need the capability study on the big chamfer for300 pcs, then we have to measure at CMM ( 3D) as GFT method.
如果您需要300个大倒角能力的研究，那么我们在三坐标测量机（3D）测量GFT的方法。 - RECHAMFER: Defect on radii and chamfer; defective chamfer such as nicks that are considered to be repairable.
重新倒角：可被重新修复的倒角缺陷，例如划痕。 - This paper analyzes the lack of traditional settingout method and the advantage of digitalization settingout method when analyzing settingout of chamfer stake in cubic meter of earth and stone.
分析了土石方工程中坡口桩放样时，传统放样方法的不足和数字化放样方法的优点。 - Fit the sealing ring at the correct position in the vacuum pump so that it is flush with the lower edge of the chamfer in the rotor.
将密封圈安装在真空泵的正确位置，以便密封圈与转子倒棱的下边缘平齐。 - Based on physical simulation of edge rolling process in Trimming-Free Plate rolling method, the affection of V rolling and chamfer rolling on the plate profile is analyzed.
基于中厚板无切边轧制法中立轧轧边变形的物理模拟，分析了平辊立轧与倒棱轧制对中厚板断面形状的影响。 - Optional accessories are: to plug, referral chamfer, outlet.
可选配件有：地插座、下线槽、出线口。 - The effects of rolling parameters such as plate width, roll contours, chamfer and straight chamfer parameters on the contact pressure distribution were studied.
研究结果表明，在轧制能力范围内，轧件越宽，轧辊采用凹辊型可以使辊身部的辊间压力分布更为均匀； - Single type angle drills: Use to machine chamfer for hole of glass, stones etc. Various type and specification.
独立倒角钻头：用于玻璃孔、石材孔倒角使用。各种型号及规格。